Table of Contents
Advertisement
Programmable DC Electronic Load 63600 Series Operation & Programming Manual
6.
Clear the Setting Sequenc
Clear the setting Sequences by turn the Rotary knob to change the display value to YES,
ENTER
then press
7.
Set the Amount of the Total Setting Sequenc
Set the Amount of the Total Setting Sequence by turn the Rotary knob to change the
display value, then press
8.
Setting Sequenc
In the page of Program Sequences Function, turn the Rotary knob to change the display
value to Sequence Setting, then press
Program Sequences Function.
a.
Setting the Sequence Mode
There are four modes to control the sequence execution.
SKIP:
Skip the sequence. Load will not change input status.
AUTO:
When Dwell time passes, the Load will get to the next sequence
automatically.
MANUAL: Press
automatically.
External: Use External signal of TRIG_ SEQ to control Load input on/off. When the
rising edge of the TRIG_ SEQ signal is action, the Load will get to the
next sequence automatically.
Turn the Rotary knob to change the display value to MANUAL, and then press
ENTER
keys to set sequence 1 to manual mode. You must set more two sequence
settings for one program. The default setting is SKIP.
b.
Select the operation mode.
There are four operation modes for Program Sequences Function. They are CC, CR,
CV and CP modes. Turn the Rotary knob to change the mode until the desired
mode is displayed on the VFD. Then, press
the setting.
4-30
e
.
key to confirm.
ENTER
key to confirm the setting.
REMAIN_SEQ : 98
CLEAR_SEQ : NO
TOTAL_SEQ : 2
e
.
SET_SEQ
ENTER
key to confirm, then the Load will get to the next sequence
TRIG : MANUAL
MODE : CC
e
.
ENTER
key into Sequence Setting page of
ENTER
key to select mode and confirm
Advertisement
Table of Contents
