Table of Contents
Advertisement
Programmable DC Electronic Load 63600 Series Operation & Programming Manual
Line fuses do not need to be changed when the line voltage is changed.
The line fuses will protect the Electronic Load from incorrect voltage
setting.
2.5.2 Turn-On Self-Test
Check the following before turning on the Load.
1.
The nominal line voltage of the AC input socket is in the range of 100-120/200-240 Vac.
2.
The power cord is connected to the AC input socket.
WARNING
The power cord supplies a chassis ground through a third connector. Be
sure that your outlet is of three-conductor type with the correct pin
connected to ground.
Power on the Load by the front panel switch on Mainframe and observe the display.
Immediately after turning on, the Electronic Load executes a self-test that checks firmware
and communication. The Load Module displays,
and then displays the model number as well as firmware version,
If any error is found during self-test, the display will stop here. Check the Load and
Mainframe connection when an error occurs. When the self-test completes, the VFD will
display measurement V & I. The dual channel module goes to L channel.
In case of failure, return the Mainframe or Load module to Chroma sales or service office for
repair.
2-6
63630-80-60
[636308000066]
G_FW : 1.00
C1_FW: 1.00
< --- Model Number
< --- Serial Number
< --- F/W version
< --- F/W version
Advertisement
Table of Contents
