Programmable DC Electronic Load 63600 Series Operation & Programming Manual
To leave out of the REMOTE edit page of system configuration, you need to press
ENTER
and
simultaneously to go back to the page of system configuration.
4.7.4 Setup of Parallel
The following is Operation Flow:
NONE
In the page of system configuration, turn the Rotary knob to change the display value to 4,
ENTER
then press
key into Parallel edit page of system configuration.
4-42
[ DIGITAL I / O ]
DOUT1 : NONE
DOUT2 : NONE
[ DIGITAL I / O ]
DIN1 : NONE
DIN2 : NONE
[ DIGITAL I / O ]
DOUT_VOLT : NONE
CONFIG
Parallel
Mode
Mode?
MASTER
INIT
ADVA
SLAVE