Chroma 63610-80-20 Operation & Programming Manual page 226

Programmable dc electronic load
Table of Contents

Advertisement

Programmable DC Electronic Load 63600 Series Operation & Programming Manual
Description:
Setting Syntax:
Setting Parameters: <NR2>, [Unit=A/μs]
Example:
LAT
Type:
Description:
Setting Syntax:
Setting Parameters: <NR1>, 0: OFF, 1: ON
Example:
GO
Type:
Description:
Setting Syntax:
Setting Parameters: <NR1>, 0: OFF, 1: ON, Other Value: no action
Example:
VRB
Type:
Description:
Setting Syntax:
Setting Parameters: <NR1>, 0: LOW range, 1: MIDDLE range, 2: HIGH range, Other
Example:
VR
Type:
Description:
Setting Syntax:
Setting Parameters: <NR2>, [Unit=Volt]
Example:
VON
Type:
Description:
Setting Syntax:
Setting Parameters: <NR2>, [Unit=Volt]
Example:
CCSR
Type:
Description:
5-94
Set the falling slew rate of CP mode to the ten channels in one
frame. The frame will ignore the setting when the channel does not
exist.
CPF<space>"n,n,n,n,n,n,n,n,n,n"
CPF "1.0,2.5,2.5,10,2.0,5.0,5.0,5.0,0,0"
All Channels
Set the action type of Von to the ten channels in one frame. The
frame will ignore the setting when the channel does not exist.
LAT<space>"n,n,n,n,n,n,n,n,n,n"
LAT "0,1,1,1,0,1,0,1,0,0"
All Channels
This command starts/stops current sinking of the ten channels in
one frame. The frame will ignore the setting if the channel does not
exist.
GO<space>"n,n,n,n,n,n,n,n,n,n"
GO "0,1,1,1,0,1,0,1,0,0"
All Channels
This command sets the voltage range of CC mode to the ten
channels in one frame. The frame will ignore the setting if the
channel does not exist.
VRB<space>"n,n,n,n,n,n,n,n,n,n"
Value: no action
VRB "0,1,1,1,0,1,0,2,0,0"
All Channels
This command sets the voltage range of CC mode to the ten
channels in one frame. The frame will ignore the setting when the
channel does not exist. The unit of the setting value is volt. Please
refer to measurement section in the Specification table.
VR<space>"n,n,n,n,n,n,n,n,n,n"
VR "1,1,2,16,80,10,80,16,0,0"
All Channels
This command sets Von voltage to the ten channels in one frame.
The frame will ignore the setting if the channel does not exist.
VON<space>"n,n,n,n,n,n,n,n,n,n"
VON "1.23,1.23,0,0,5,5,12,12,0,0"
All Channels
Set both of the rising and the falling slew rate of CC mode to the ten

Advertisement

Table of Contents
loading

Table of Contents