Test Procedure - Keysight NFA Series Performance Verification And Calibration Manual

NOTE
Step 1. Connect the equipment as shown in Figure 2-16.
Step 2. Set the Synthesized Sweeper as follows:
Step 3. Ensure that the preset is set to factory settings (press the
Step 4. Press the
Step 5. Run the IF attenuator calibration routine (press the
Step 6. Record the results. Press the

Test Procedure

Throughout the Gain Measurement Uncertainty Test Procedure the
term 'the Worksheet' refers to the Gain Measurement Uncertainty Test
Worksheet 1 on page 69 or Worksheet 2 on page 71, and the term 'the
Test Record' refers to the Gain Measurement Uncertainty Test Record
detailed in the relevant Appendix for the model number being tested.
1. Press the key.
Preset
2. Set the frequency to 50 MHz (press the
3. Set the power level to -46 dBm (press
4. Switch .
RF ON
5. Set the frequency mode to fixed (press
and ).
Mode Fixed
6. Set the frequency to 50 MHz (press
, then
Frequency 5
then ,
More Power On/Preset
key on the NFA and wait until the routine is finished.
Preset
, and
More More Service
Then press , followed by
Service
approximately 30 seconds to complete the routine.
routine is complete. Use the tab keys below the display to scroll through
the results. Press [
|<—
corresponding index value in the Worksheet No. 1.
Chapter 2
Frequency/Points
, , ).
0 MHz
,
Power On (Preset)
. Press
Enter password
and
IF Test
Gain Lin Results
] or [ ]). Record the Delta results along side the
—>|
Test Descriptions
Gain Measurement Uncertainty
key, then , ,
CW 5 0
, then ,
Power Level - 4
key,
Frequency/Points
key,
Fixed
System
and
Preset (Factory)
key, then
System
, then
-, 2, 0, 1, 0
. The test takes
Gain Lin Test)
menu item once the above
).
MHz
,
, ).
6 dB(m)
Frequency
key,
).
Enter.
and
67