Wieland samos PRO Manual page 98

Instance Byte Access
read
140 30 to 49 Write,
read
141 40 to 49 Write,
read
57 0 to 49 Read
50 to 65 Read
66 Read
167 0 to 49 Read
50 Read
51 Read
52 to 111 Read
The data type of supported assemblies is BYTE which means strings of 8 bits each. The naming in
Logix Designer is SINT, which has the same size of 8 bits each.
If PLC requires a configuration assembly, any value or blank can be used for assembly instance. Si-
ze of the configuration assembly shall be zero.
Please use assembly instances from Table "Overview of Assembly data bytes [ch. 8.5.1, p. 97]" for In-
put and Output. These settings can be used in generic EtherNet module configuration in Logix De-
signer which can be seen in the illustration below.
Wieland Electric GmbH | BA000970 | 07/2019 [9855]
Data type Description
mosPLAN 6 (see [ch. 8.5.2, p. 99])
BYTE[20] Logic output bytes, configuration
via Input data block 4 and 5 in
samosPLAN 6 (see [ch. 8.5.2, p. 99])
BYTE[10] Logic output bytes, configuration
via Input data block 5 in samos-
PLAN 6 (see [ch. 8.5.2, p. 99])
BYTE[50] Logic output bytes, configuration
via Output data block 1 in samos-
PLAN 6 (see [ch. 8.5.3, p. 100])
BYTE[16] Values of the input terminals Ix
BYTE Input and output state
BYTE[50] Logic output bytes, configuration
via Output data block 1 in samos-
PLAN 6 (see [ch. 8.5.3, p. 100])
BYTE Bit 7: Input state
Bit 6: Output state
Bit 5: Error code ≠ 0
BYTE System mode
State bytes of the controller module
BYTE[60]
(Instance 3 of class 120 [ch. 8.4.8.3, p.
94]), output data set 3 (siehe [ch.
8.5.3, p. 100])
EtherNet/IP gateway
Size Data range
Bytes
1 to 20 0 to 0xff
Bytes
1 to 10 0 to 0xff
Bytes
1 to 50 0 to 0xff
Bytes
1 to 16 0 to 0xff
Bytes
1 byte 0x00, 0x40,
0x80, 0xc0
1 to 50 0 to 0xff
Bytes
1 byte 0x00, 0x40,
0x80, 0xc0
1 byte 1, 2, 3, 4, 5, 7,
21
60 byte 0 to 0xff
98