Function And Basic Settings; Routing; Basic Settings For The Process Data - Wieland samos PRO Manual

Illustration 7: Configuration dialog in the "Properties" docking window
5.2

Function and basic settings

81134347
5.2.1

Routing

81142283
The process diagram, transferred to the network from the samosPRO gateway, comprises the opera-
ting data (e.g. logic results, state of inputs and outputs) and the diagnostic data (e.g. module status,
CRCs). This data have been arranged in 4 data sets.
Table 22: Content of data sets 1–4
Data set
1
2
3
4
The process data in Data Set 1 may consist of up to 50 bytes, irrespective of the network protocol
used. These 50 bytes have been divided into one or several data blocks, depending on the network
protocol. Detailed information about the modularization of the data sent to the network may be
found in the section on the relevant gateway and in the following table: "Preset configuration for
process data transmitted in the network" [ch. 5.2.2, p. 46]
The content of data set 1 has been pre-configured with the addition of a gateway module or a gate-
way function, but can be freely configured with a granularity of 1 byte (see Basic settings for process
data [ch. 5.2.2, p. 45] and Configuring the gateway output values (tab 1) [ch. 5.3, p. 47]).
The diagnostic data in data sets 2-4 depends on the network protocol used and is described in the
chapter on the relevant gateway.
5.2.2

Basic settings for the process data

81160331
After the addition of the gateway, the process data is pre-configured. Depending on the gateway
used, this data is divided into several data blocks.
Wieland Electric GmbH | BA000970 | 07/2019 [9855]
Configuration of gateways with samosPLAN 6
Content
Process data
CRCs
State and diagnosis
Reserved
Size Configurable
50 bytes Yes
32 bytes No
60 bytes No
60 bytes No
45