Wieland samos PRO Manual page 78

The SP-COP2-ENI module is a General Purpose Discrete I/O Device. For quick installation, use the
connection Logic Output (1 to 400) and Logic/Physical Input, if your PLC supports implicit messa-
ge transmission. The following figure shows the appropriate dialog in the Logix Designer.
Illustration 16: Basic connection selected in the Logix Designer
This connection comprises up to 50 bytes for data transmission from the PLC to the SP-COP2-ENI
module (assembly instance 37). This connection comprises up to 67 bytes for data transmission
from the SP-COP2-ENI module to the PLC (assembly instance 57). The following table offers an over-
view of these data bytes.
Table 38: Data of the class 1 connection "Logic output (1 to 400) and logic/physical input"
Instance Byte Access
37 0 to 49 Write, read BYTE[50]
57 0 to 49 Read
50 to 65 Read
66 Read
Wieland Electric GmbH | BA000970 | 07/2019 [9855]
Data type Description
Output bytes, configuration via
Input data block 1 to 5 in
samosPLAN 6
(More [ch. 8.5.2.1, p. 99])
BYTE[50] Input bytes, configuration via
Output data block 1 in samos-
PLAN 6
(More [ch. 8.5.3.1, p. 100])
BYTE[16] Bits of the input terminals
(instance 401 to 528 of attribu-
te 3 class 8, currently not listed
in samosPLAN 6 )
(More [ch. 8.5.3.1, p. 100])
BYTE Bit 7: Input state
Bit 6: Output state
(currently not listed in samos-
PLAN 6 )
EtherNet/IP gateway
Size Data range
1 to 50 Bytes 0 to 0xff
1 to 50 Bytes 0 to 0xff
1 to 16 Bytes 0 to 0xff
1 byte 0x00, 0x40,
0x80, 0xc0
78