Expert setting: Allocating bytes to other addresses
samosPLAN 6 has pre-assigned the addresses according to a default. You can manually change this
address allocation by moving any number of bytes.
In our example, we have shifted byte 1 to byte 23 in output data block 0.
Step 1: Check target address
Ensure that the desired address (byte 23 in our example) has not been allocated.
When the target address is assigned here, delete the bytes placed there.
To do this, click on the byte in the work area and click on the Delete symbol in the command
bar.
Step 2: Delete byte from original address
Delete the byte you wish to reallocated (byte 0 in our example).
To do this, click on the byte in the work area and click on the Delete symbol in the command
bar.
Wieland Electric GmbH | BA000970 | 07/2019 [9855]
EtherCAT Gateway
171