Product Description; Version, Compatibility, And Features - Wieland samos PRO Manual

3

PRODUCT DESCRIPTION

77437579
samosPRO gateways allow a samosPRO system to transmit non-safety-related data for control and
diagnostic purposes to the external field bus system and to receive them.
Important safety information
Do not operate a samosPRO gateway on a safety field bus!
The gateway modules are not suitable for operation with a safety field bus!
They do not only generate safety-related field bus data (state bytes) for control and diagnostic
purposes. They do not support any safety mechanisms that would be required for communication
ATTENTION
within a safety network.
Information on the function, configuration and designations
NOTICE
Where not otherwise indicated, this manual always considers the data exchanged between the
samosPRO system and the relevant network from the point of view of the network master (PLC).
Thus data sent to the network from the samosPRO system is termed input data, while data recei-
ved from the network is termed output data.
Configuration of samosPRO gateways takes place via the samosPLAN 6 configuration software, using
a PC or Notebook connected to the SP-COPx main module via the USB interface or RJ45 Ethernet in-
terface.
The safety-related logic of the samosPRO system works independently of the gateway. However, if
the system has been configured in such a way that non-safety-related information from the field bus
can be integrated into the logic editor, switching off the gateway may result in availability problems.
A samosPRO gateway can only be operated on a samosPRO system. It does not have its own power
supply. A maximum of two samosPRO gateways can be operated simultaneously for each system.
The gateway for Modbus TCP, PROFINET IO or EtherNet/IP is integrated into the SP-COP2-ENI con-
troller module, while the gateways for Profibus-DP, CANopen or EtherCAT are housed in a 22.5 mm
wide installation housing for 35 mm hat rails in accordance with EN 60715.
Order information: Order data [ch. 13, p. 189]
3.1

Version, compatibility, and features

77848715
There are various module versions and function packages for the samosPRO product family that
enable various features. This section will give you an overview as to which module version, which
function package, and/or which version of the samosPLAN 6 you will need to be able to use a certain
function or a certain device.
Table 3: Required versions of the controller module
Feature/
functionality
Modbus TCP
PROFINET IO
EtherCAT (SP-EN-ETC)
EtherNet/IP
PROFIBUS DP
CANopen
Wieland Electric GmbH | BA000970 | 07/2019 [9855]
Available with controller module version and higher
SP-COP1-x SP-COP2-EN-x
--- ---
--- ---
C-01.xx C-01.xx
--- ---
A-01 A-01
A-01 A-01
Product description
SP-COP2-ENI-x samosPLAN 6
A-01 V1.0
B-01.xx V1.0
C-01.xx V1.0
D-01.xx V1.0
A-01 V1.0
A-01 V1.0
17