Accessing The Inverter With Starter Via Step 7 - Siemens SINAMICS G110M Function Manual

Appendix
A.1 Communication with STEP7
A.1.2.3

Accessing the inverter with STARTER via STEP 7

Adapting the PROFINET interface
If you wish to commission the inverter with STARTER via PROFINET, then you must
address your PC and assign STARTER to the interface via which STARTER goes online
with the inverter.
Procedure
To address the inverter, proceed as follows:
1. Establish the bus connection.
See Section Integrating inverters into PROFINET (Page 59))
2. From the control panel, assign the IP address and the subnet mask address to your
computer:
3. Go to "Start/Settings/Control Panel".
4. Select "Network Connections".
5. Right-click to open the properties window of the LAN connection.
6. In this window, select "Internet Protocol (TCP/IP)".
7. Select "Properties".
8. As IP address of the supervisor, set 192.168.0.100 and as subnet mask 255.255.255.0
ein.
In a company network, it is possible that other values apply for the IP address and the
subnet mask. You can obtain these values from your network administrator.
222
Function Manual, 01/2016, FW V4.7 SP6, A5E34229197B AC
Fieldbuses