Siemens SINAMICS G110M Function Manual page 208

Communication via AS-i - only for G110M
7.3 Dual Slave mode
master (Page 210).
Default setting 34, slave 1 with profile 7.A.5: Control -> inverter
• AS-i.DO0
• AS-i.DO1
• AS-i.DO2
• AS-i.DO3
Default setting 34, slave 1 with profile 7.A.5: Inverter -> control
• p2080[4] = 722.2
• p2080[5] = 722.3
• Serial data transfer CTT2, four bytes cyclically or acyclically via PIV.
The reading and writing of parameters is possible via the PIV.
Because data is transferred bit-by-bit, the read and write process is
very slow.
• Time signal for the CTT2 transfer to the AS-i master
208
Table 7-5 Alarm and fault messages via RP0 ... RP3 from the inverter to the AS-i
-> Time signal for the CTT2 transfer from the AS-i master
-> Data bit for the CTT2 transfer, four bytes cyclically or acyclically via
PIV. The reading and writing of parameters is possible via the PIV.
Because data is transferred bit-by-bit, the read and write process is
very slow.
-> p0881 = 2093.4
-> Select slave A or slave B, interconnected internally
State DI2
State DI3
Override quick stop
Function Manual, 01/2016, FW V4.7 SP6, A5E34229197B AC
-> AS-i.DI0
-> AS-i.DI1
-> AS-i.DI2
-> AS-i.DI3
Fieldbuses