Inserting The Inverter Into The Project - Siemens SINAMICS G110M Function Manual

Appendix
A.1 Communication with STEP7
6. Create a PROFIBUS DP network.
You have created a STEP 7 project with a SIMATIC control and a PROFIBUS network.
A.1.1.2

Inserting the inverter into the project

There are two ways to insert an inverter into the project:
● Using the inverter GSD
● Using the STEP 7 object manager
This more user-friendly method is only available when STARTER is available.
Using an example of a SINAMICS G120 with Control Unit CU240B-2 or CU240E-2, the
procedure shows how you insert the inverter into the project using the GSD.
Precondition
You have installed the GSD of the inverter in your PC using HW Config (menu "Options -
Install GSD files").
Procedure
In order to insert an inverter into your project, proceed as follows:
1. Insert the inverter by dragging and dropping it into the PROFIBUS network.
You can find the inverter under "PROFIBUS DP - Other field devices" in the HW Config
hardware catalog.
2. Enter the PROFIBUS address set at the inverter in HW Config.
3. Select the appropriate telegram and insert the telegram into slot 1 of the inverter by
dragging and dropping.
Telegram types:
4. If you wish to assign several inverter slots with telegrams, then you must comply with the
permitted sequence of slot assignments.
216
Cyclic communication (Page 15).
Function Manual, 01/2016, FW V4.7 SP6, A5E34229197B AC
Fieldbuses