Requirements On The Personnel Conducting The Work; Disassembly; Storage Conditions; Recommissioning - Baumuller BM5-O-SAF-000 Operating Instructions Manual

19.2

Requirements on the personnel conducting the work

19.2 Requirements on the personnel conducting the work
The personnel you assign to carry out the disassembly must have the knowledge and
training necessary to perform this work properly. The personnel should be selected so
that it will be able to understand and use the safety instructions attached to the device
and its components as well as the connections.

19.3 Disassembly

The personnel carrying out the disassembly must meet the requirements above.
Carry out the disassembly process in the following order:
1 Make sure that the power has been disconnected and cannot be turned back on
2 Disassemble the plug-in module in the reverse order of the assembly (see chapter
3 Document the disassembly (or exchange) of the plug-in module.
Document the disassembly (or exchange) of the converter, if applicable.
Document the disassembly (or exchange) of the additional system components, if
applicable.

19.4 Storage conditions

Store the plug-in module in a suitable package under the storage conditions specified in
the

19.5 Recommissioning

If you want to put the plug-in module back into operation, observe the specifications under
„Storage conditions". Then conduct the
from page 77 onward again.
94 Operation Manual Safety Module for b maXX 5000 BM5-O-SAF-000/-001
Document no.: 5.09013.07
of 114
WARNING!
Danger of injury due to uncontrollable behavior of the machine/line.
The behavior of the machine/line can change as a result of removing the component
assembly with the power source connected.
Therefore:
m Make sure that the power to all electrical connections is shut off and secured to
prevent from being turned back on.
m Using suitable measuring equipment, check to make sure that none of the
connections are carrying live current before beginning work on the electrical
connections.
m Only disassemble the connections and remove the connection once you are
completely certain that the component assembly is not under power.
accidentally.
ZAssembly and installation–
ZTechnical data–
from page 103 onward.
from page 71 onward).
ZCommissioning and exchange of the module–
Baumüller Nürnberg GmbH