Table of Contents
Advertisement
5.2
Requirements of the personnel carrying out work
5.2
Requirements of the personnel carrying out work
DANGER
The following will occur, if you do not observe this danger information:
m serious personal injury
Danger from: electricity. The unit and the vicinity of the control cabinet may carry dangerous
voltages.
Before starting any work, ensure that the unit and its vicinity are free of voltage.
Observe the relevant safety regulations when handling current-carrying units.
Ensure that only qualified personnel assembles and installs this plug-in module.
Qualified personnel is considered to be people whose training, experience and knowl-
edge of relevant standards and regulations, accident prevention regulations and condi-
tions in the plant has led to their being authorized by the plant safety manager to carry out
activities that are needed in each case while recognizing and avoiding any possible haz-
ards that might arise. The qualifications that are necessary for working with the unit in-
clude, for example:
m Trained or instructed in accordance with recognized safety standards in the care and
5.3
Preparation
h Consult the type code (see "D" in
Figure 5:
: CANsync-Master for b maXX PLC
h Determine the correct slot (see
22
Operating Instructions CANsync-Master Option Module for BM4-O-PLC BM4-O-CAN-06
Document No.: 5.02056.01A
von 56
m death
use of appropriate safety equipment
correct plug-in module.
ZFigure5
on page 22) to ensure that you have the
ZFigure6
on page 23).
Baumüller Nürnberg Electronic GmbH & Co. KG
Advertisement
Table of Contents
