Assembly And Installation; General Safety Regulations - Baumuller BM5-O-SAF-000 Operating Instructions Manual

This chapter describes the mechanical assembly and electrical installation of the plug-in
module.
The assembly and installation process consists of the following steps:
1 Assemble the plug-in module.
2 Connect the plug-in module to the safety components (for example, emergency stop
3 Check the assembly and installation by means of the „Installation checklist" listed in

12.1 General safety regulations

CAUTION!
The „Installation checklist" reproduced in Appendix
used during the assembly and installation phase.
m Make sure that the installation process is carried out entirely in accordance with
m Conduct a visual inspection and check all system components for visible damage.
m Check the system for wiring errors.
m Inspect the tightening torque and make sure that the electrical connection is not
m Inspect the tensile-load capacity of the electrical terminal and screw connections.
m Make sure that the installation and cable routing are carried out in accordance with
m Make sure that the system's environmental properties specified in Appendix
m Make sure that the design of the system's type of protection is sufficient.
m Make sure that the safety system is not damaged by moving parts or work in the
m Make sure that the system components do not come into contact with aggressive
Operation Manual Safety Module for b maXX 5000 BM5-O-SAF-000/-001
A
SSEMBLY AND INSTALLATION
12
device, electromechanical safety component, ...).
ZB.2–
Appendix on page 101.
the installation and wiring plan.
interrupted by insulation material.
applicable standards and guidelines.
ZC.2.1–
on page 103 are not exceeded.
area surrounding the installed safety components.
substances (such as acids, bases, transmission oil).
ZB.2–
on page 101 should be
Document no.: 5.09013.07
71
of 114