This chapter describes the error indications of the Safety Module (SAF-001).
16.1 Safety regulations
Observe the applicable safety regulations, see
16.2 Requirements on the personnel conducting the work
Personnel working with the Safety Module (SAF-001) must be instructed in the safety
regulations and the operation of the module and be familiar with the proper operation of
the system. The reaction to error indications and statuses in particular requires special
knowledge which the operator must have.
16.3 Error diagnosis
Fail-safe principle
The Safety Module (SAF-001) is based on the fail-safe principle. This means that each
error automatically causes the module to switch into the safe status STO (Safe Torque
Off).
The red LED on the front panel of the Safety Module (SAF-001) indicates the error status
(see chapter
WARNING!
Do not put a defective safety-oriented system back into operation as long as the
cause of the error is unknown to you or an error has not been rectified.
Operation Manual Safety Module for b maXX 5000 BM5-O-SAF-000/-001
T
ROUBLESHOOTING AND
16
ZLEDs for indicating the operation statuses
RECTIFICATION
ZSafety
ab Seite 17.
ab Seite 54).
Document no.: 5.09013.07
87
of 114