System Validation; Function Test - Baumuller BM5-O-SAF-000 Operating Instructions Manual

All safety functions as well as the trouble-free functioning of the installed system must be
tested with the initial operation. The testing of the system must be documented.
WARNING!
Danger during commissioning!
The Safety Module may only be put into operation after being tested successfully by
a technical expert.
Therefore:
m Conduct a complete function test. In doing so, check the correct allocation of the
m A checklist for the commissioning and validation of the system is reproduced in
m Make sure that operating personnel has been instructed in the handling of the

14.1 Function test

The function test is a major part of the validation of the entire system. The function test is
used to determine the trouble-free allocation of the network safety components and the
programmed logic of the system.
Depending on the complexity of the logic circuit of the respective project, it is
recommended to conduct the function tests in steps.
The following course of action is recommended when conducting the function tests:
1 Only connect the actuators and drives to the safe output terminals once no errors have
2 Conduct a complete function test with all sensors (initiators), switches, actuators and
Operation Manual Safety Module for b maXX 5000 BM5-O-SAF-000/-001
connected safety components.
ZB.3 Commissioning and validation checklist–
Appendix
Conduct the validation of the system in accordance with this checklist and
document the procedure accordingly.
Safety Module.
been detected in the inspection of the logic circuit.
drives.
To conduct the function tests, trigger all safety functions sequentially and document the
system's reaction. Check whether their action corresponds with the expected behavior.
S
YSTEM VALIDATION
14
Document no.: 5.09013.07
from page 102 onward.
83
of 114