Requirements On The Personnel Conducting The Work - Baumuller BM5-O-SAF-000 Operating Instructions Manual

13.2

Requirements on the personnel conducting the work

13.2 Requirements on the personnel conducting the work
The commissioning work may only be conducted by professionally trained personnel, in
particular personnel which understands the safety regulations and can follow them.
78 Operation Manual Safety Module for b maXX 5000 BM5-O-SAF-000/-001
Document no.: 5.09013.07
of 114
DANGER!
Danger of injury due to moving parts!
Machine parts/line parts or the entire machine/line can move during commissioning.
The „Planning checklist" reproduced in the appendix
checklist– from page 102 is to be used in the commissioning phase.
Therefore:
m Maintain an adequate distance from moving machine parts/line parts or from the
moving machine/line.
m Note that the machine parts/line parts or machine/line can be set in motion via
additional modules connected to the Safety Module.
m Activate the safety devices in any case prior to switching on the system.
m Make sure that the system is commissioned exclusively by qualified personnel.
m Make sure that there are no people in the danger zone during the initial
commissioning. Always anticipate that a machine, system or safety device may not
behave as it is intended to.
m If changes or expansions are conducted during the commissioning process, the
effects on the behavior of the system will have to be inspected. To do this, it will be
necessary to process the checklists for the planning and installation phase again.
DANGER!
Danger from mechanical action!
The machine/line or parts of the machine or line can be started during the
commissioning of the Safety Module.
Therefore:
m Maintain an adequate distance from moving machine parts/line parts or from the
moving machine/line.
ZCommissioning and validation
Baumüller Nürnberg GmbH