Working Principle Parameter Module (Bm5-O-Saf-000-000-000) - Baumuller BM5-O-SAF-000 Operating Instructions Manual

7.3

Working principle parameter module (BM5-O-SAF-000-000-000)

7.3 Working principle parameter module (BM5-O-SAF-000-000-000)
The adjusted parameters of the b maXX 5000 axis unit can be stored on the SAF-000 pa-
rameter module. The parameter backup is carried out by the parameterization software
ProDrive. The software provides this function with adequate buttons at the page „Data set
management". By selecting these buttons parameter data can be written to or read from
the SAF-000.
Figure 1:
NOTICE!
The parameter data cannot be copied to the SAF-000 Parameter module, if a com-
plete data set which was loaded before of that from the RAM with all the parameters, 
was loaded in the flash memory of the b maXX 5000 again.
32 Operation Manual Safety Module for b maXX 5000 BM5-O-SAF-000/-001
Document no.: 5.09013.07
of 114
Data set management ProDrive
Baumüller Nürnberg GmbH