Description Of The Reset-Module; General; Compatibility List; Operating Mode Of The Reset-Module (Bm5-O-Saf-100) - Baumuller BM5-O-SAF-000 Operating Instructions Manual

This chapter describes the BM5-O-SAF-100 (Reset-Module) with its function and ex-
plains the type code on the module.
9.1

General

In order to operate the axis unit of the series b maXX 5000 the slot A of the device must
be equipped with a module (also see 5.09021, instruction handbook b maXX 5000). In
case the device was previously equipped with a higher safety level, the parameter stor-
age of the converter must be reset with the Reset-Module (BM5-O-SAF-100) or with a re-
set command (see
9.2

Compatibility list

The Reset-Module (BM5-O-SAF-100) can only be used in the combination with convert-
ers of the type b maXX 5000, which where released by Baumüller Nürnberg GmbH.
9.3

Operating mode of the Reset-Module (BM5-O-SAF-100)

In order to reset the module ID of the converter the slot A of the device must be equipped
with a Reset-Module. After switching on the voltage supply of the converter the ID of the
previously equipped modules is deleted.
After 15 seconds the voltage supply can be switched off and the slot A can be equipped
with the requested Safety Module.
An operation of the converter with the Reset-Module is not possible, because the module
does not provide supply for the converter's drivers.
Operation Manual Safety Module for b maXX 5000 BM5-O-SAF-000/-001
D
ESCRIPTION OF THE
9
ZResetting of the safety level by the controller–
R
M
ODULE
on page 65).
Document no.: 5.09013.07
-
ESET
61
of 114