Table of Contents
Advertisement
A
SSEMBLY AND INSTALLATION
5
In this chapter, we will describe mechanical assembly and electrical installation of a CAN-
sync-Master option module for b maXX PLC.
Assembly/installation consists of the following steps:
1 Mount the plug-in module.
2 Connect the plug-in module to the signal cables and the power supply.
5.1
General safety regulations
h Observe the information in chapters
ZBasic Safety Instructions –
from page 7 onward.
h Observe all areas on the b maXX unit that could be dangerous when you are carrying
out assembly.
The figure below gives you an overview of the danger zones on the plug-in module.
Figure 4:
Danger zones
21
Operating Instructions CANsync-Master Option Module for BM4-O-PLC
BM4-O-CAN-06
von 56
Advertisement
Table of Contents
