Table of Contents
Advertisement
2.9
Responsibility and liability
.
WARNING
The following may occur, if you do not observe this warning information:
m serious personal injury
Any and all persons who work on and with Series b maXX units must always have available
these Operating Instructions and must observe the instructions and information they contain
– this applies in particular to the safety instructions.
Apart from this, any and all persons who work on this unit must be familiar with and observe
all the rules and regulations that apply at the place of use.
2.9.2
Danger arising from using this module
The CANsync-Master option module has been developed and manufactured to the state
of the art and complies with applicable guidelines and standards. It is still possible that
hazards can arise during use. For an overview of possible hazards, refer to the chapter
entitled
We will also warn you of acute hazards at the appropriate locations in this documentation.
2.9.3
Warranty and Liability
All the information in this documentation is non-binding customer information; it is subject
to ongoing further development and is updated on a continuous basis by our permanent
change management system.
Warranty and liability claims against Baumüller Nürnberg Electronic GmbH & Co. KG are
excluded; this applies in particular if one or more of the causes listed in
Use –
m Disaster due to the influence of foreign bodies or force majeure.
14
Operating Instructions CANsync-Master Option Module for BM4-O-PLC BM4-O-CAN-06
Document No.: 5.02056.01A
von 56
m death
ZBasic Safety Instructions –
from page 12 onward or below caused the fault:
from page 7 onward and to
Baumüller Nürnberg Electronic GmbH & Co. KG
ZFigure3
on page 19.
ZInappropriate
Advertisement
Table of Contents
