Siemens SIMATIC NET IE/AS-INTERFACE LINK PN IO Manual page 183

A AS-Interface Protocol Implementation Conformance Statement (PICS)
Table A-2 , (Fortsetzung)
No. Function or Call on the Host Interface
(symbolic representation)
7 Status = Store_Actual_Parameters()
8 Status =
Set_Permanent_Configuration(Addr,
Config)
9 Status, Config =
Get_Permanent_Configuration(Addr)
10 Status = Store_Actual_Configuration()
11 Status, Config =
Read_Actual_Configuration(Addr)
12 Status = Set_LPS(List31)
13 Status, List31 = Get_LPS()
14 Status, List31 = Get_LAS()
15 Status, List32 = Get_LDS()
16.0 Status = Get_Flags()
16.1 Status, Flag = Get_Flag_Config_OK()
16.2 Status, Flag = Get_Flag_LDS.0()
16.3 Status, Flag =
Get_Flag_Auto_Address_Assign()
16.4 Status, Flag =
Get_Flag_Auto_Prog_Available()
16.5 Status, Flag =
Get_Flag_Configuration_Active()
16.6 Status, Flag =
Get_Flag_Normal_Operation_Active()
16.7 Status, Flag = Get_Flag_APF()
16.8 Status, Flag = Get_Flag_Offline_Ready()
16.9 Status, Flag = Get_Flag_Periphery_OK()
17 Status = Set_Operation_Mode(Mode)
18 Status = Set_Offline_Mode(Mode)
19 Status = Activate_Data_Exchange(Mode)
20 Status = Change_Slave_Address(Addr1,
Addr2)
21.1 Status = Set_Auto_Address_Enable
21.2 Status = Get_Auto_Address_Enable
22.1 Status, Resp =
Cmd_Reset_ASI_Slave(Addr, RESET)
IE/AS−INTERFACE LINK PN IO
Release 08/2018
C79000−G8976−C216−03
as of hardware version 1, as of firmware version V2.0
M4 Comment / Function implemented by / see
Section
X see Section 8.2
X see Section 8.2
X see Section 8.2
X By keypad and display; also with a call
(see Section 8.2)
X see Section 8.2
X see Section 8.2
X see Section 8.2
X see Section 8.2
X see Section 8.2
X see Section 8.2
X see Section 8.2
X see Section 8.2
X see Section 8.2
X see Section 8.2
X see Section 8.2
X see Section 8.2
X see Section 8.2
X see Section 8.2
X see Section 8.2
X By keypad and display;
also with a call (see Section 8.2)
X see Section 8.2
− optional call
X see Section 8.2
X see Section 8.2
X see Section 8.2
− optional call
183