Siemens SIMATIC NET IE/AS-INTERFACE LINK PN IO Manual page 139

Byte
Bit 7 Bit 6
Parameter 30/30B
169
P3 P2
170
171
Flag 1
Bit Number Meaning
0 CONFIG_OK
1 LDS_0
2 AUTO_ADDR_ASSIGN
3 AUTO_ADDR_AVAIL
4 CONFIG_MODE
5 NORMAL_MODE
6 APF
7 OFFLINE_READY
In the table, the rows of the flags whose values change the mode of the AS-i
master (CONFIG_MODE, AUTO_ADDR_ENABLE) are shown in white.
The values of the other flags (gray in the table) have no significance for the
'Set_LPS_PCD_PP_Flags' call and cannot be modified on the AS-i master with
this call..
The meaning of the flags is the same as in the "Get_LPS_LAS_LDS_LPF_Flags"
job, Section 8.2.1.4).
IE/AS−INTERFACE LINK PN IO
Release 08/2018
C79000−G8976−C216−03
Meaning
Bit 5 Bit 4
P1 P0
Flag 1
Flag 2
as of hardware version 1, as of firmware version V2.0
8 Using the Data Record Interface
Bit 3 Bit 2
Parameter 31/31B
P3 P2
Flag 2
Bit Number Meaning
0 PERIPHERY_OK
1 DATA_EXCHANGE_ACTIVE
2 OFFLINE
3 AUTO_ADDR_ENABLE
4 Ground short
5 EPROM_OK
6 reserved
7 reserved
Bit 1 Bit 0
P1 P0
139