MITSUBISHI CNC
1 System Configuration
1.1 System Basic Configuration Drawing
Control unit
Synchronous feed
encoder
(Note 1) Control unit is mounted on the back side of the display unit.
(Note 2) Operation panel I/O unit is mounted on the back side of the keyboard unit.
(Note 3) For the drive unit configuration, refer to the Instruction Manual of the drive unit you use.
2
Display unit
Remote I/O
unit
Manual pulse
generator
Keyboard unit
Remote I/O
unit
Manual pulse
generator
Operation panel
I/O unit
Servo/Spindle drive units
Motors