Buick LeSabre 1965 Service Manual page 825

1 1 - 9 2 OPTIONAL HEATER-AIR CONDITIONER SYSTEM
ACCESSORIES
Figure 11-98—Removing Shaft Nut
Figure 11-100—Removing Clutch Drive
Plate Retainer Ring
Figure 11-103-Torquing Shaft Nut
Figure 11-99—Removing Clutch
Drive Plate
c. Pulley Assembly and
Bearing Removal
1. Remove clutch drive plate.
Subparagraph "a".
2. Remove pulley assembly re-
tainer ring, using J-6435, No. 26
Truarc Pliers. See Figure 11-104.
3. Place J-9395 Puller Pilot over
compressor shaft and remove
pulley assembly, using J-8433
Puller. See Figure 11-105.
IMPORTANT: Puller Pilot J-9395
must be used, or force will cause
shaft to move in swash plate,
resulting in damage to the cylin-
der mechanism.
Figure 11-101—Positioning Clutch
Drive Plate on Shaft
NOTE: Do not remove pulley
bearing unless it is going to be
replaced.
4. Remove bearing to pulley re-
tainer wire with a small screw-
driver. See Figure 11-106.
5. Remove bearing, using punch
or a suitable socket.
Figure 11-104—Removing or Installing
Bearing to Head Retainer Ring
d. Pulley Assembly and
Bearing Installation
If the existing pulley assembly
and clutch drive plate are to be
reused, clean the friction faces on
each part with trichlorethylene,
alcohol or similar solvent. If
PRESS CLUTCH DRIVE
PLATE O N UNTIL THERE
IS APPROXIMATELY
3
/
32
" GAP BETWEEN
SURFACE OF PLATE
D PULLEY
Figure 11-102—Installing Clutch
Drive Plate
Figure 11-105—Removing Pulley
Assembly