Buick LeSabre 1965 Service Manual page 269

SUPER TURBINE " 3 0 0 ' SERVICE PROCEDURES 5 - 5 5
Figure 5-264
Figure 5-267
6. Install the input sun g e a r 9. Install the rear planet pinion
thrust washer with the oil groove thrust washer. Oil groove must
facing input sun gear. See Figure be toward pinion gear. See Figure
5-265. 5-268.
NOTE: The front thrust washer
already installed with the long
planet pinions also is used for
the short planet pinions as the
two (2) pinions are paired to-
gether on one set of t h r u s t
washers.
THRUST
WASHERS
PINION
SHAFT
NEEDLE
BEARINGS
Figure 5-270
certain that it picks up the thrust
washers. Turn the pinion shaft
so the groove faces center of
planet carrier. See Figure 5-272.
Figure 5-265
7. Install input sun gear into
planet carrier. See Figure 5-266.
Figure 5-266
8. Install low sun gear needle
thrust bearing. See Figure 5-267.
Figure 5-268
10. Install twenty (20) n e e d l e
bearings, and one thrust washer
in the pinion gear. See Figure
5-270. With a twisting motion,
lock the needle rollers in place.
See Figure 5-271.
11. Position short planet pinion
assembly and thrust washers at
each end of the planet carrier.
Install pinion shaft from the front
of planet carrier. As the pinion
shaft is being pushed in, make
Figure 5-271
Figure 5-272