Assembly Of Units Into Transmission Case - Buick LeSabre 1965 Service Manual

SUPER TURBINE " 4 0 0 '
DISASSEMBLY & ASSEMBLY 5 - 1 3 9
Figure 5-700
b. Install the t h r u s t bearing
against the race.
c. Install the second race, center
flange up. See Figure 5-701.
16. Install the bronze center sup-
port to reaction carrier thrust
washer into the recess in the
c e n t e r support. Retain with
petrolatum. See Figure 5-702.
17. Using Tool J-21367, as a
pilot, install the rear sprag as-
sembly on case center support
inner r a c e with b r o n z e drag
strips up. See Figure 5-703.
18. Install the case center sup-
port and sprag assembly as
follows:
a. Place a rubber band on the
sprag assembly O.D. to hold the
Figure 5-702
in
Figure 5-705
and finish installation by pressing
on c a s e support. See F i g u r e
5-705.
NOTE: With r e a c t i o n carrier
held, case support should only
turn counterclockwise.
19. Install output shaft to case
thrust washer, tags in pockets.
5 - 2 7 ASSEMBLY OF
UNITS INTO
TRANSMISSION
CASE
Figure 5-703
1. Install the "O" ring seal on
p l a c e . See Figure the park pawl shaft.
INSTALL—REAR SPRAG
sprags
5-704.
2. Install the parking pawl, tooth
b. Start sprag assembly into out- toward the inside case and park-
er race, remove the rubber band ing pawl shaft. See Figure 5-706.
Figure 5-701
Figure 5-704
Figure 5-706