Buick LeSabre 1965 Service Manual page 272

5 - 5 8 SERVICE PROCEDURES
SUPER TURBINE " 3 0 0 '
Figure 5-287
4. Install seventeen (17) clutch
piston return springs. See Figure
5-290.
Figure 5-290
5. Position piston return seat on
piston return springs. Place snap
ring on return seat so that ring
may be easily installed when seat
is compressed with tool. See Fig-
ure 5-291.
REVERSE
PISTON
SEAT
-J-21420-1
SNAP RING
Figure 5-292
6. Using J-21420-1 and J-21420-2
compress piston return seat so
snap ring may be installed with
J-5586 Pliers. See Figure 5-292.
CAUTION:
edge
Make certain inner
of seat does not hang up
on snap ring groove while being
compressed.
7. Install reverse clutch cushion
spring. See Figure 5-293.
Figure 5-294
NOTE: Cars equipped with V-6
engines have 4 driven and 4 drive
clutch plates. Cars equipped with
V-8 engine have 5 driven and 5
drive clutch platesT
9. Install reverse clutch pres-
sure plate with the identification
mark being installed in the 5
o'clock groove in case. See Fig-
ure 5-295.
REVERSE CLUTCH
CUSHION SPRINGS
Figure 5-291
Figure 5-293
8. Align notches on the steel
driven plates. Install the steel
driven plates and lined drive
plates alternately, beginning with
a steel driven plate. The notched
lug on each driven plate goes in
the 5 o'clock groove in case. See
Figure 5-294.
CAUTION: S t e e l p l a t e s are
waved and should all face same
direction. For this reason notches
are provided to indicate correct
installation.
Figure 5-295
10. Install reverse clutch pack
snap ring. See Figure 5-296.
Figure 5-296