Buick LeSabre 1965 Service Manual page 271

SUPER TURBINE " 3 0 0 '
SERVICE PROCEDURES 5 - 5 7
seal points toward center of case.
See Figure 5-277.
4. With a twisting motion insert
outer range selector lever into
case. See Figure 5-278.
5. Assemble park lock actuator
assembly to inner park lock and
range ^selector. See Figure 5-280.
RETAINER RING.
PARK LOCK m
ACTUATOR \ _ > J 9
ASSEMBLY ^ d B y ^
INNER PARK LOCK
. .AND RANGE
k/SELECTOR LEVER
•L
Figure 5-280
6. Install outer range selector
lever to selector lever shaft.
7. Install inner park lock and
range selector assembly to outer
range selector lever. Install nut
on range selector lever. See Fig-
ure 5-281.
Figure 5-282
8. Slide outer range selector
lever into case and tighten nut
using a 9/16" wrench. See Figure
5-282.
Figure 5-283
9. Install range selector shaft re-
tainer. See Figure 5-283.
NNER PARK
K AND RA
ELECTOR
Figure 5-281
NOTE: Make certain longest end
on range selector lever is to the
bottom of transmission.
Figure 5-284
10. Install parking bracket to
transmission case. Torque bolts
to 8-12 ft. lbs. torque. See Figure
5-284.
11. If outer range selector lever
was removed install nut torque
to 20-30 ft. lbs.
c. Installing Reverse Clutch
REVERSE CLUTCH PISTON
OUTER SEAL
Figure 5-285
1. Lubricate with transmission
oil and install reverse clutch pis-
ton outer seal. See Figure 5-285.
REVERSE CLUTCH %
PISTON INNER
w
SEAL
Figure 5-286
2. Lubricate with transmission
oil and install reverse clutch pis-
ton inner seal. See Figure 5-286.
3. With transmission in vertical
position install the reverse clutch
piston into case. Tap piston with
hammer handle to make certain
piston is seated in case. See Fig-
ure 5-287.