Buick LeSabre 1965 Service Manual page 265

SUPER TURBINE " 3 0 0 ' SERVICE PROCEDURES 5 - 5 1
Figure 5-240
CAUTION: If wood block is
placed under nylon gear, break-
age of gear i n s i d e governor
sleeve will result. Exercise ex-
treme care not to damage ma-
chine s u r f a c e s of governor
sleeve.
2. Remove driven gear. Remove
any chips or burrs from inside
governor sleeve.
b. Installation
1. Install replacement g e a r by
carefully pressing new gear into
sleeve as follows:
a. Use press plate J-8853.
b. Place shim supplied in re-
placement gear kit between the
second and third lands of gover-
nor sleeve. See Figure 5-241.
c. Make certain new gear is po-
sitioned squarely on sleeve and
press gear onto sleeve. Gear
must be seated against sleeve.
See Figure 5-241.
If either secondary tab wear or
less than .019 feed port opening
is found, the complete governor
assembly must be replaced.
a. Removal
1. Support governor s l e e v e on
wood block as shown in Figure
5-240, remove roll pin with a
1/8" drill rod.
THROUGH EXISTING HOLE
IN METAL GOVERNOR
SLEEVE, DRILL A 1/8" HOLE
THROUGH NYLON GEAR.
CAREFUL ALIGNMENT MUST
BE MADE TO MAKE
STRAIGHT HOLE FOR
RAIL PIN INSTALLATION
WOOD BLOCK
Figure 5-241
Figure 5-242