Buick LeSabre 1965 Service Manual page 249

SUPER TURBINE "300'
SERVICE PROCEDURES 5 - 3 5
11. Remove valve body plate. See
Figure 5-118.
12. On V-6 m o d e l s note the
identification notch. See Figure
5-120.
1. Release tension on low band
adjusting screw retaining nut. Re-
lease t e n s i o n on low band by
turning adjusting s c r e w in a
counterclockwise direction. Use a
7/32" Allen Wrench. See Fig-
ure 5-122.
Figure 5-120
.VALVE BODY
TO CASE GASKE
Figure 5-123
2. Remove low servo cover snap
ring. Use Tool J-21495 to com-
press servo cover so snap ring
can be r e m o v e d . See Fig-
5-123.
NOTE: Use thumb pressure only
to tighten screw on Tool J-21495.
Figure 5-121
13. Remove valve body plate to
case gasket. See Figure 5-121.
d. Removal of Low Servo
Cover and Piston
Assembly
Figure 5-122
Figure 5-124
3. Remove tool J-21495-1 from
case. Remove low servo cover.
NOTE: If necessary aid removal
with s c r e w d r i v e r . See Fig-
ure 5-124.
NOTE: If low servo cover has to
be replaced make certain all
model information is stamped on
new cover.
4. Inspect low servo cover seal.
LOW SERV
COVER
Figure 5-125
Figure 5-126
If nicked, torn or worn discard.
See Figure 5-125.
5. Remove low s e r v o piston
assembly from case. See Fig-
ure 5-126.
NOTE: When r e m o v i n g low
servo cover take extreme care
not to disturb low band apply
strut.
5 - 1 1 REMOVAL OF OIL
PUMP, FORWARD
CLUTCH, AND
LOW BAND
a. Removal of Oil Pump
1. With transmission in vertical
position, remove eight (8) pump
attaching bolts with "O" ring
seals, then install Slide Ham-
mers J-7004 into threaded holes
in pump. Using slide hammers,
loosen pump from case. Remove
pump and gasket from case. See
Figure 5-127.