Forward Clutch Disassembly, Inspection And Reassembly; Disassembly Of - Buick LeSabre 1965 Service Manual

SUPER TURBINE " 4 0 0 '
DISASSEMBLY & ASSEMBLY 5 - 1 2 5
Figure 5-606
NOTE: Leave the bolts one turn
loose at this time.
11. Place Pump Aligning Strap,
J-21368, over pump body and
Figure 5-607
Figure 5-610
cover, and tighten tool. See Fig-
ure 5-607.
12. Tighten pump cover bolts.
13. Install 15-20 ft. lbs. torque
and align pump to case gasket.
14. Attach stator solenoid with
bolts. See Figure 5-608.
15. Attach stator wire to clip.
16. Install pump to case "O"
ring seal.
5 - 2 0 FORWARD CLUTCH
DISASSEMBLY,
INSPECTION AND
REASSEMBLY
a. Disassembly
1. Place forward clutch and tur-
bine shaft in hole in bench and re-
FORWARD
CLUTCH HUB
FORWARD CLUTCH
HOUSING
Figure 5-612
move the forward clutch housing
to direct clutch hub snap ring.
See Figure 5-610.
2. Remove the direct clutch hub.
See Figure 5-611.
3. Remove the forward clutch hub
and thrust washers. See Figure
5-612.
4. Remove five (5) composition
and five (5) steel clutch plates.
See Figure 5-613.
NOTE: The BU Model used on
LeSabre series cars has (4) com-
position and (4) steel.
5. If necessary remove turbine
shaft. See Figure 5-614.
6. Using J-2590 clutch spring
compressor, compress the spring
retainer and remove the snap
ring. See Figure 5-615.
GASKET
STATOR SOLENOID
^
FORWARD
CLUTCH
HOUSING
Figure 5-608
Figure 5-611 Figure 5-613