Buick LeSabre 1965 Service Manual page 179

CLUTCH, S-M TRANSMISSION
46000 SYNCHROMESH 4 - 4 3
REAR BEARING
RETAINER
SOFT
HAMMER
Figure 4-89—Spreading Rear Bearing
Snap Ring
ring when reassembling trans-
mission and do not expand snap
ring further than is necessary
for assembly.
3. Install rear bearing retainer.
Spread snap ring in rear bearing
retainer to allow snap ring to
drop around rear bearing. Press
on the end of mainshaft until snap
ring engages groove in the rear
bearing retainer.
4. Install 1st-reverse s l i d i n g
gear on mainshaft. See Figure
4-94.
5. Install second speed gear, hub
forward, over front end of main-
shaft. See Figure 4-95.
6. Install 2nd-3rd speed clutch
sleeve on clutch hub as shown in
Figure 4-96.
7. Place synchronizing ring on
rear of sleeve and hub assembly,
CLUTCH KEY CLUTCH KEY SPRING CLUTCH HUB
4
CLUTCH KEY
CLUTCH KEY
Figure 4-91—Clutch Hub Assembly
Figure 4-90—Removing Rear Bearing
Snap Ring
making sure slots in ring are
aligned with clutch keys.
8. Install sleeve, hub, and syn-
chronizing ring a s s e m b l y on
mainshaft. See Figure 4-96.
Figure 4-93—Installing Rear Bearing
Figure 4-92—Installing Rear Bearing Snap Ring