Buick LeSabre 1965 Service Manual page 7

0 - 4 INTRODUCTION
MODEL
PRODUCTION
DAY BUILT
YEAR
401 and 425 cu. in. V-8
Production Code No.
Serial No.
Figure 0-3—Transmission Identification -
Super Turbine " 3 0 0 "
300 cu. in. V-8
Production Code No.
Serial No.
Stamped on the right
side of the crankcase
and can be viewed be-
tween the m i d d l e
branches of the right ex-
haust manifold.
Stamped on the left front
face of the crankcase,
just below the rocker
arm cover. On cars
equipped with power
steering it will be nec-
essary to remove the
power steering pump
bracket to view the com-
plete number.
Is stamped on the front
edge of the crankcase
just to the right of the
thermostat housing.
When viewed from the
front of the car it will
appear upside down.
Is stamped on the front
edge of the crankcase
just to the left of the
thermostat housing.
When viewed from the
front of the car it will
appear right side up.
Automatic Transmission Identification Numbers -
On Super Turbine "300" transmissions, identifi-
cation information is stamped on the low servo
cover as shown in Figure 0-3. On Super Turbine
"400" transmissions, this information can be
found on a plate attached to the right side of the
case.
Synchromesh Transmission Serial Numbers - All
synchromesh transmissions have a serial number
stamped on the case. This number should be used
in identifying transmissions on product reports.
See Figures 0-5, 0-6, and 0-7.
Rear Axle Marking - Figures 0-8 and 0-9 show
the identification marking found on the rear axle.
This information should also be included on prod-
uct reports involving the rear axle.
YEAR TRANS.
A R
MODEL
PRODUCTION
DAY BUILT
m
^—. } ^
|7|p—
FRONT VIEW
OF TRANSMISSION
^ = - DAY OF
MONTH
^
= : : a
' MONTH
SAGINAW
(M) MUNCIE
Figure 0-4—Transmission Identification
Super Turbine " 3 0 0 "
Figure 0-5—LeSabre 3-Speed Synchromesh
Transmission Identification