Buick LeSabre 1965 Service Manual page 347

SUPER TURBINE " 4 0 0 '
DISASSEMBLY & ASSEMBLY 5 - 1 3 3
Figure 5-667
INTERMEDIATE
CLUTCH PISTON
J-2590-3
Figure 5-668
7. Inspect the piston for cracks
or porosity.
8. Inspect the release springs for
distortion.
Figure 5-671
c. Assembly
1. Install new inner seal on the
piston with lip of the seal facing
away from the spring pocket. See
Figure 5-668.
2. Install new outer seal.
Figure 5-670.
See
3. Install inner seal protector,
Tool J-21363, on the center sup-
port hub, install the piston. See
Figure 5-671.
4. Install twelve (12) r e l e a s e
springs into the piston. See Fig-
ure 5-672.
5. Place the spring retainer and
snap ring over the springs.
6. Using the Clutch Spring Com-
pressor, J-2590, compress the
springs and install the snap ring.
See Figure 5-673.
Figure 5-673
Figure 5-674
7. Install four (4) hook type oil
rings. See Figure 5-674.
8. Air check operation of inter-
mediate clutch piston. See Fig-
ure 5-675.
INTERMEDIATE CLUTCH
RELEASE SPRING (12)
Figure 5-670
Figure 5-672 Figure 5-675