Buick LeSabre 1965 Service Manual page 262

5 - 4 8 SERVICE PROCEDURES
SUPER TURBINE " 3 0 0 '
Figure 5-217
9. Lift up on forward clutch pis-
ton with a twisting motion and
remove. See Figure 5-217.
Figure 5-218
10. Examine forward clutch pis-
ton outer seal. If nicked, torn or
worn, remove seal. See Figure
5-218.
11. Examine forward clutch pis-
ton inner seal. If nicked, torn or
worn, remove seal. See Figure
5-220.
Figure 5-221
12. Check forward clutch drum
bushing for nicks, severe scoring
or wear. If bushing replacement
is necessary proceed as follows:
Using Tool J-21424-5, p r e s s
damaged bushing from forward
clutch drum. See Figure 5-221.
Figure 5-220
Figure 5-222
13. Check low sun gear and flange
assembly b u s h i n g for nicks,
severe scoring, or wear. If bush-
ing replacement is necessary
proceed as follows: Support low
sun gear assembly on press plate
using Tool J-21424-4 and Drive
Handle J-8092 press out bushing.
See Fig. 5-222.
b. Inspection
1. Wash all parts in a suitable
cleaning solvent. Use compressed
air to dry.
2. Cneck steel ball in the forward
clutch drum. Be sure it is free
to move in hole and that orifice
leading to front of clutch drum
is open.
3. Check clut.ch plates for wear
or scoring.
c. Reassembly
Figure 5-223
1. Install J-21424-5 in front of
forward clutch drum. Using Drive
Handle J-8092 press bushing into
bore until Tool J-21424-5 bottoms
on hub. See Figure 5-223.
Figure 5-224
2. Install Tool J-21424-4 into low
sun gear. Using Drive Handle