Installation Of Rear Servo Assembly - Buick LeSabre 1965 Service Manual

5 - 1 4 4 DISASSEMBLY & ASSEMBLY
SUPER TURBINE "400'
Figure 5-734
12. Install the connector with the
lock tabs facing into the case.
See Figure 5-735.
13. Install detent connector ter-
minal into stator connector, push-
ing inward so that t e r m i n a l
connections are locked.
NOTE: Check by pulling on de-
tent connector wire. If detent
connector wire can be removed,
turn wire connector over and re-
install into stator connector. If
both wires were removed, rein-
stall as shown in Figure 5-736.
5 - 3 1 INSTALLATION OF
REAR SERVO
ASSEMBLY
NOTE: Before installing the rear
servo assembly check band apply
Figure 5-736
pin using Tool J-21370 as follows:
a. Attach the band apply pin Se-
lection Gauge J-21370, to the
transmission case with attaching
screws. NOTE: Attach tool at-
taching screws finger tight and
check freeness of pin. Torque
attaching screw and recheck to
make certain pin does not bind.
b. Apply 25 ft. lb. torque and se-
lect proper servo pin to be used
from scale on tool. See Figure
5-737.
c. Remove the tool and make
note of the proper pin to be
used during assembly of the
transmission.
There are three selective pins
identified as follows:
Pin Identification
Two three rings
Two Rings
One Ring
Pin Size
Long
Med.
Short
Figure 5-735
The identification ring is located
on the band lug end of the pin.
Selecting the proper pin is the
equivalent of adjusting the band.
1. Install rear a c c u m u l a t o r
spring into case.
2. Install rear servo assembly
into case. See Figure 5-738.
Figure 5-737
REAR SERVO
>
\
V
•
ASSEMBLY
Figure 5-738
3. Install the rear servo gasket
and cover. See Figure 5-740.
4. I n s t a l l a t t a c h i n g screws.
Torque bolts to 15-20 ft. lbs. See
Figure 5-741.
Figure 5-740