Buick LeSabre 1965 Service Manual page 355

SUPER TURBINE " 4 0 0 '
DISASSEMBLY & ASSEMBLY 5 - 1 4 1
Figure 5-715
Figure 5-716
14. Install the backing plate to
case snap ring. Gap in snap ring
should be opposite anchor pin.
See Figure 5-718.
15. Check rear end play as fol-
Figure 5-720
lows: See Figure 5-720.
a. Install J-7004 into an exten-
sion housing attaching bolt hole.
See Figure 5-720.
b. Mount the Dial I n d i c a t o r ,
J-8001, on the rod and index with
the end of the output shaft.
c. Apply air pressure to apply the
intermediate clutch (center oil
passage) while moving the output
shaft in and out to read the end
play. End play should be from
.003"-.019". The selective wash-
er controlling this end play is
the steel washer having 3 lugs
that is located between the thrust
washer and the rear face of the
transmission case.
If a different washer thickness is
required to bring the end play
within specification, it can be se-
lected from the following chart.
Notches
Thickness
,078 -
,086 -
094 -
102 -
,110 -
118 -
.082
.090
.098
.106
.114
.122
Figure 5-718
None
1 Tab Side
2 Tabs Side
1 Tab O.D.
2 Tabs O.D.
3 Tabs O.D.
16. Install front band with band
anchor hole placed over the band
anchor pin and apply lug facing
servo hole. See Figure 5-721.
17. Install the direct clutch and
intermediate sprag assembly. It
Figure 5-721
will be necessary to twist the
housing to allow the sprag outer
race to index with the clutch drive
plates. The housing hub will bot-
tom on the sun gear shaft. See
Figure 5-722.
NOTE: Removal of direct clutch,
drive and driven plates, may be
helpful.
18. Install the forward clutch hub
to direct clutch housing bronze
thrust washer on the forward
c l u t c h hub. R e t a i n with
petrolatum.
19. Install the forward clutch and
torque shaft assembly, indexing
the direct clutch hub so end of the
mainshaft will bottom on end of
the forward clutch hub. When for-
ward clutch is seated it will be
Figure 5-722