Buick LeSabre 1965 Service Manual page 346

5 - 1 3 2 DISASSEMBLY & ASSEMBLY
SUPER TURBINE " 4 0 0 '
SNAP RING
J-2590-3
Figure 5-660
SPRING RETAINER
W
r
Figure 5-661
2. Using Clutch C o m p r e s s o r
J-2590, compress the spring re-
tainer and remove the snap ring.
See Figure 5-660.
CLUTCH
RELEASE SPRING
INTERMEDIATE
CLUTCH PISTON
CENTER SI
& RACE ASSEMBLY
Figure 5-663
3. Remove the spring retainer.
See Figure 5-661. Remove twelve
(12) clutch release springs. See
Figure 5-662.
4. Remove the i n t e r m e d i a t e
clutch piston. See Figure 5-663.
5. Remove the inner piston seal.
See Figure 5-664.
NOTE: Do not remove the three
(3) bolts retaining the sprag inner
race to the center support.
6. Remove the outer piston seal.
See Figure 5-665.
b. Inspection
1. Inspect the sprag inner race
for scratches or indentations. Be
sure the lubrication hole is open.
See Figure 5-666.
Figure 5-665
2. Inspect the bushing for scor-
ing, wear or galling. If replace-
ment is necessary proceed as
follows:
a. Using
bushing.
Tool J-21465-6 remove
b. From sprag side of support in-
stall bushing using toolJ-21465-6.
Install bushing flush to .010 below
counterbore.
3. Check the oil ring grooves for
damage.
4. Air check the oil passages to
be sure they are open and not
interconnected. See Figure 5-667.
5. Inspect for piston sealing sur-
faces for scratches.
6. Inspect the piston seal grooves
for nicks or other damage.
CENTER SUPPORT
Figure 5-662 Figure 5-664 Figure 5-666