Buick LeSabre 1965 Service Manual page 274

5 - 6 0 SERVICE PROCEDURES
SUPER TURBINE " 3 0 0 '
b. Installation of Low Band
Figure 5-306
1. With transmission in vertical
position install band adjusting
screw into case. See Figure
5-306.
4. Install low band apply strut and
band adjusting screw strut. After
both struts have been installed,
tighten low band adjusting screw
enough to prevent struts from
falling out. See Figure 5-311.
c. Installing the Forward
Clutch Assembly
Figure 5-313
clearance. There are three se-
lective thrust washers available,
.099/.095, .081/.077 and .063/.059.
Select end washer so the clear-
ance will be between .022" and
.054". See Figure 5-313.
Figure 5-307
2. Install low band into case. See
Figure 5-3O7
f
3. This picture is for illustration
purposes only. It shows the
proper positioning of the low band
apply strut and band adjusting
screw anchor strut. See Figure
5-310.
Figure 5-312
Figure 5-314
NOTE:
BAND APPLY STRUT
POINT UPWARD
Figure 5-310
1. Install forward clutch assem- 2. Grease and install selective
bly turning slightly to engage low fit washer to pump cover hub.
sun gear with planet pinions. See See Figure 5-314.
Figure 5-312.
d. Check Forward Clutch to
Oil Pump Clearance
1. Attach slide hammer bolt to
threaded hole in oil pump. With
flat of hand on end of input shaft
move so parts are clear back.
Install dial indicator set on rod
and "O" dial indicator on end of
input shaft. Push on end of output
shaft to move everything forward
r
the reading obtained will be the
Figure 5-315