Buick LeSabre 1965 Service Manual page 349

SUPER TURBINE " 4 0 0 ' DISASSEMBLY & ASSEMBLY 5 - 1 3 5
PINION PIN
BRONZE WASHER
STEEL WASHER
HEADED END
PLANET PINION
NEEDLE BEARINGS
STEEL WASHER
BRONZE WASHER
Figure 5-681
2. Inspect the bearing and thrust
washer surfaces for damage.
3. Inspect the governor drive
gear for rough or damaged teeth.
4. Inspect the splines for damage.
5. Inspect the orificed cup plug
in the lubrication passage.
6. Inspect
damage.
the drive lugs for
b. Inspection of Rear
Internal Gear
1. Inspect the g e a r
damage or wear.
teeth for
Figure 5-682
Figure 5-683
2. Inspect the splines for damage.
3. Inspect the gear for cracks.
c. Inspection of Sun Gear
1. Inspect gear teeth for damage
or wear.
2. Inspect splines for damage.
3. Inspect the gear for cracks.
d. Inspection of
Sun Gear Shaft
1. Inspect shaft for cracks or
splits.
2. Inspect splines for damage.
3. Inspect bushings for scoring
or galling.
4. Inspect the ground bushing
journals for damage.
5. Be sure the oil lubrication hole
is open.
e. Inspection of
Turbine Shaft
1. Inspect for open lubrication
passages at each end.
2. Inspect the splines for damage.
3. Inspect the ground bushing
journals for damage.
4. Inspect the shaft for cracks
or distortion.
f. Inspection of Main Shaft
1. Inspect the shaft for cracks or
distortion.
2. Inspect the splines for damage.
3. Inspect the ground bushing
journals for damage.
4. Inspect the snap ring groove
for damage.
5. Inspect the orificed cup plug
pressed into one end of the main-
shaft. Be sure it is not plugged.