Buick LeSabre 1965 Service Manual page 263

SUPER TURBINE "300'
SERVICE PROCEDURES 5 - 4 9
J-8092 press bushing into low sun
gear until bushing installer is
flush with top of low sun gear.
See Figure 5-224.
NOTE: A satisfactory tool can
be made by crimping a loop of
.020" music wire in a short length
of copper tubing.
.mo" mm
Figure 5-225
3. Lubricate with transmission
oil and install new forward clutch
piston inner seal with seal lip
pointing downward. See Figure
5-225.
NOTE: Run hand around seal
after it is installed to see if seal
is fully in groove.
Figure 5-227
CLUTC
SPRI
Figure 5-228
6. Carefully reassemble return
springs, retainer and snap ring.
See Figure 5-228.
7. With spring retainer in place
compress spring retainer with
Tools J-2590-3, J-2590-4 and
J-2590-5 far enough so the spring
retainer snap ring can be in-
stalled. Make sure r e t a i n e r
doesn't catch in snap ring groove
when compressing springs. See
Figure 5-230.
NOTE: Place a piece of hard
board between Tool J-2590-3 and
forward clutch drum.
ALIGN TANGS
IN CLUTCH HUB
WITH GROOVES
IN THRUST
WASHER
Figure 5-231
8. Install clutch hub front thrust
washer to clutch hub (retain with
grease) aligning tangs in clutch
hub with g r o o v e s in thrust
washer. Install clutch hub. See
Figure 5-231.
Figure 5-226
4. Lubricate with transmission
oil and install new forward clutch
piston outer seal in clutch piston.
Seal lip must point down. See
Figure 5-226.
5. Install forward clutch piston
into clutch drum using a loop of
smooth wire to start lip of seal
into bore. Piston should turn
freely. See Figure 5-227.
ALIGN NOT
THE STEEL
PLATES
Figure 5-230 Figure 5-232