Buick LeSabre 1965 Service Manual page 251

SUPER TURBINE " 3 0 0 "
SERVICE PROCEDURES 5 - 3 7
/
REAR BEARING
RETAINER
Figure 5-135
socket. Remove rear bearing
retainer from case. See Fig-
ure 5-135.
Figure 5-136
2. Remove rear bearing retainer
oil seal. See Figure 5-136.
c. Removal of Rear Bearing
Retainer Oil Seal
SCREWDRIVER
PUT SHAFT
EAR BEARING
INER
EAL
1. Inspect and if necessary re-
move output shaft to rear bearing
r e t a i n e r oil seal. See Fig-
ure 5-137.
d. Removal of Rear Bearing
Retainer Bushing
NOTCH IN REAR
BEARING RETAINER
REAR BEARING
RETAINER
BUSHING
Figure 5-138
1. Inspect and if necessary re-
place rear bearing retainer bush-
ing. Place screwdriver in notch
in rear bearing retainer, then
tap screwdriver w i t h hammer
to collapse bushing. See Fig-
ure 5-138.
e. Removal of Governor
Figure 5-137
Figure 5-140
1. R e m o v e three (3) attaching
bolts retaining governor cover to
case using a 1/2" socket. Re-
move cover and gasket. See Fig-
ure 5-140.'
2. With a twisting motion slide
governor assembly out of its bore
in case. See Figure 5-141.
Figure 5-141
5 - 1 3 SPEEDOMETER
DRIVE GEAR AND
VACUUM
MODULATOR
a. Removal of Speedometer
Driving Gear
J-21427
SPEEDOMETER
DRIVING GEAR
Figure 5-142
1. Place transmission in Park
range, then remove speedometer
driving gear with J-9578. See
Figure 5-142.
2. When removing speedometer
driving gear on extended wagons
use slide hammer bolts in con-
junction with detail J-9578.
b. Removal of the Vacuum
Modulator Assembly
1. Remove vacuum modulator re-
tainer bolt and retainer using a
1/2" socket. Remove vacuum
modulator and valve assembly.
See Figure 5-143.