Buick LeSabre 1965 Service Manual page 352

5 - 1 3 8 DISASSEMBLY & ASSEMBLY
SUPER TURBINE "400'
Figure 5-692
5. Place the above portion of the
"build-up" through hole in bench
so that the m a i n s h a f t hangs
downward.
6. Install the rear internal gear
to output shaft thrust races and
bearings as follows; and retain
w i t h petrolatum. See Figure
5-692.
a. Place the small diameter race
against the internal gear with the
center flange facing up.
b. Place the bearing on the race.
c. Place the second race on the
bearing with the outer flange
cupped over the bearing.
7. Install the output shaft into the
output carrier a s s e m b l y . See
Figure 5-693.
Figure 5-694
Figure 5-695
8. Install the output shaft to out-
put carrier snap ring. See Figure
5-694.
9. Turn assembly over and sup-
port so that the output shaft hangs
Figure 5-697
downward. See Figure 5-695.
10. Install the reaction carrier to
output carrier thrust washer with
the tabs facing down in pockets.
See Figure 5-696.
11. Install the sun gear splines
with chamfer down. See Figure
5-697.
12. Install ring over output car-
rier. See Figure 5-698.
13. Install the sun gear shaft.
14. Install the reaction carrier.
See Figure 5-700.
15. Install the center support to
sun gear thrust races and bearing
as follows:
a. Install the large race, center
flange up over the sun gear shaft.
Figure 5-693
Figure 5-696 Figure 5-698