Buick LeSabre 1965 Service Manual page 180

4 - 4 4 46000 SYNCHROMESH
CLUTCH, S-M TRANSMISSION
REVERSE
Figure 4-94—Installing Ist-Reverse
Sliding Gear
9. Secure clutch hub with retain-
ing snap ring. See Figure 4-97.
10. Press speedometer d r i v e
gear onto mainshaft, using Press
Plate J-8853. See Figure 4-98.
11. Position the speedometer
gear 7-1/2" from the rear of the
gear to the rear of mainshaft.
12. C o u n t e r g e a r Assembly -
Steps 12-18.
Figure 4-95—Installing Second Speed
Gear
CLUTCH SLEEVE
CLUTCH HUB
Figure 4-97—Clutch Hub Snap Ring
13. I n s t a l l
countergear.
roller spacer in
Figure 4-98—Speedometer Drive Gear
14. Using heavy grease to retain
the rollers, install 20 rollers in
either end of the countergear,
two .050" s p a c e r s , 20 more
rollers, then one .050" spacer.
Install in the other end of coun-
tergear, 20 more rollers and an-
other .050" spacer. See Figure
4-99.
15. Place l a r g e bronze thrust
washer at front end of counter-
gear, tang facing out so that it
will seat in groove at front of
case. Retain with heavy grease.
16. Place smaller bronze thrust
washer against rear of counter-
gear, tangs facing gear and seated
in grooves. Retain with grease.
17. Through rear of case, insert
countergear assembly, large gear
end toward front of case. Rest
countergear assembly on bottom
of case.
18. Place steel thrust washer at
rear of countergear b e t w e e n
bronze thrust washer and case,
positioning tang on steel thrust
washer in groove in case.
19. Install oil retaining washer
on main drive gear, depressed
side up. See Figure 4-100.
20. Press bearing onto main
drive gear (snap ring groove to
front). See Figure 4-101.
SPACER
SLEEVE
Figure 4-96—Installing 2nd & 3rd
Speed Clutch Hub & Sleeve Figure 4-99—Countergear