Buick LeSabre 1965 Service Manual page 273

SUPER TURBINE " 3 0 0 '
SERVICE PROCEDURES 5 - 5 9
1. Install low servo piston as-
sembly into case. See Figure
5-302.
Figure 5-297
11. Insert feeler gauge between
reaction plate and adjacent faced
plate. See Figure 5-297. Clear-
ance for the reaction plates are
shown below:
Three selective plates are re-
leased for service. These plates
are identified with one, two or
three identification marks. Plates
are graduated in size with one
identification mark b e i n g the
smallest. The clearance should
be .020" - .058".
d. Installing Planetary
Gear Set
1. Install thrust bearing race with
a lip, needle bearing, and a sec-
ond plain thrust bearing race to
the rear face of the planetary
gear set. Retain with grease. See
Figure 5-298.
Figure 5-300
2. Install reverse ring gear into
case. Rock and turn ring gear to
pick up clutch plate splines. See
Figure 5-300.
LOW SERV
COVER
Figure 5-303
2. Install low servo cover oil
seal. See Figure 5-303.
Figure 5-301
3. Install planetary gear set into
case. See Figure 5-301.
5 - 2 4 INSTALLATION OF
LOW SERVO
ASSEMBLY,
LOW BAND, AND
FORWARD CLUTCH
Figure 5-304
to
3. Install low servo cover
case. See Figure 5-304.
4. Compress low servo cover
with J-21495 and install retaining
snap ring. See Figure 5-305.
Installation of Low Servo
Figure 5-298 Figure 5-302
Figure 5-305