Center Support And Intermediate; Clutch Disassembly, Inspection; And Reassembly - Buick LeSabre 1965 Service Manual

SUPER TURBINE " 4 0 0 '
DISASSEMBLY & ASSEMBLY 5 - 1 3 1
DIRECT CLUTCH
BACKING PLATE
COMPOSITION
PLATES (5)
STEEL
PLATES (5)
Figure 5-652
the the drive lugs one above
other. See Figure 5-652.
9. Install the clutch backing plate.
10. Install the backing plate re-
taining snap ring. See Figure
5-653.
11. Turn unit over and install one
sprag bushing, cup side up, over
inner race.
12. Install s p r a g assembly into
outer race.
13. With ridge on inner cage fac-
ing down start sprag and outer
race over inner race with clock-
wise turning motion. See Fig-
ure 5-654.
NOTE: Outer race should not
turn counterclockwise.
Figure 5-654
Figure 5-655
14. Install s p r a g retainer over
sprag, cup side down. See Fig-
ure 5-655.
15. Install sprag retainer and
snap ring. See Figure 5-656.
Figure 5-657
16. Place direct clutch assembly
over center support and air check
operation of direct clutch. See
Figure 5-657.
NOTE: If air is applied through
reverse passage it will escape
from the direct clutch passage.
This is normal.
5 - 2 2 CENTER SUPPORT
AND INTERMEDIATE
CLUTCH DISAS-
SEMBLY, INSPECTION
AND REASSEMBLY
a. Disassembly
1. Remove four (4) hook type oil
seal rings from center support.
See Figure 5-658.
SNAP RING
SPRAG RETAINER
CENTER
SUPPORT
ASSEMBLY ^agST
/ <Mz
^ \ OIL SEAL
i RINGS
Figure 5-653
Figure 5-656
Figure 5-658