Loading Auxiliary Files Through Web Interface - AudioCodes E-SBC User Manual

CHAPTER 44 Loading Auxiliary Files
●
●

Loading Auxiliary Files through Web Interface

The following procedure describes how to load Auxiliary files through the Web interface.
●
●
●
➢
To load Auxiliary files through Web interface:
1. Open the Auxiliary Files page:
● Toolbar: From the Actions drop-down menu, choose Auxiliary Files.
● Navigation tree: Setup menu > Administration tab > Maintenance folder > Auxiliary
Files.
You can automatically load Auxiliary files from a remote server, using the device's
Automatic Update mechanism (see
Saving Auxiliary files to flash memory may disrupt current traffic on the device. To
avoid this, disable all traffic on the device by performing a graceful lock (see
Locking and Unlocking the
When loading an ini file through the Auxiliary Files page (as described in this
section), only parameter settings specified in the ini file are applied to the device; all
other parameters remain at their current settings.
If you load an ini file containing Auxiliary file(s), the Auxiliary files specified in the
file overwrite the Auxiliary files currently installed on the device.
For the User Information file, only use the Auxiliary Files page for backward
compatibility. If backward compatibility is not needed, load the file or configure
users in the User Information table for SBC users (see
Information Table through Web Interface
Configuring Gateway User Information Table through Web Interface
Mediant 1000 Gateway & E-SBC | User's Manual
Automatic Update
Device).
on page 478) and for Gateway users (see
- 860 -
Mechanism).
Configuring SBC User
on page 473).